H3 bulb (55w) 2-light type headlight.Hi / Low switching type.(Two lights will not be lit at the same time.) Fix either with the included U-shaped bracket (M6 holes at 2 positions) or remove the bracket and fix with the side M6 screws. Hi / Low switching type.(Two lights will not be lit at the same time.Fix with the attached U-shaped bracket (M6 holes x 2) or remove it and fix with the side M6 screws.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
Recently viewed products
Ratings & reviews for this product or related products
I bought it about 7 years ago for my DRZ400SM, and I always use it after all. I've put at least 20,000 miles on it since then and haven't had any problems attributed to the product. The Coking of the glass is a little bit messy (it is buried firmly), and the packing of the back cover is not reliable, but it has withstood the vibration of DRZ for several years and tens of thousands of kilometers, and the size is small and the light intensity that can pass the vehicle inspection (it seems to be the limit), so I am very satisfied with the performance. For me, it's more about the design than the performance.View Detail
I came here looking for Headlight that can be used for CenterAir Intake of Cowl of RS250Type. Since there was no Instruction Manual, hang on the Engine, plug in the Connector and check on lighting (low&high) Wiring while doing. Since the structure can not be exchanged if the light bulb runs out, it will be replaced entirely. I think both the low and high light levels are sufficient. At installation, turn angle adjustment Screw (Loosen or tighten) , Body also moves so it may take time to adjust the optical axis I do not think so.. View Detail
As the other review was staggering, I tried purchasing it with the feeling of the worst material Especially in a nice sense at Level which can be used normally without problems Whether there is a disappointment or a temporary period was bad ... Rubber packing of Coking around Lens and Wiring of the back is also normal Large seems to be durable
The discontent point is as short as Wiring Well I just need to extend it, but I guess it's okay to be long There is no way to replace Valve in the Instruction Manual Perhaps it is likely to replace if you remove the lid on the back, but there is no explanation at all After Bracket, since the horizontally long hole is empty, the mount can be lowered to a considerably low position (Wiring's Cover and Bracket's Double-sided Tape are here)View Detail
Wiring had just come out for a long time to a slight degree. Since it was somewhat short, pains was taken over management. Although appearance is the highest and becomes empty!View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!