*The actual product may differ in some colors and shapes due to improvements and specification changes. *There may be changes in product specifications due to the manufacturer's reasons.
* The image is only for reference. The image shown may differ from the actual product.
Points of Attention
* If there may be an instruction manual included, it will be written in Japanese.
The GSX-R1000R is an Other Brand Product, but also has a Rear Carrier Because it is not sold and Seat bag does not have enough carrying capacity and water proofing performance For large capacity loading & security & waterproofing, a rear box is installed Decision Purchased
The price is a little high, but when I installed it, Large processing is not necessary, and it is a little pompously installed I'm happy with the installation and Large variant!
As a general comment, there is no large wobble, and I can use Rear Sets and Carrier depending on my mood It only takes me a minute to make the switch I don't want a permanent Carrier on a regular basis! I only need to use the tear box for touring This is very much a product of Recommendation if you're not! (There is a slight reluctance when locking to the Rear Sets, so if you are concerned about it, the Rear rack side may need to be beveled a bit.)
Normally, in the case of the Rear Carriers like Pipe, the maximum loading weight is about 5kg Subtracting the weight of 5kg of the tear box, the weight of the load can be reduced by putting the tear box on the ground I guess it's fated to be in the mainstream state of Limit and not be able to put anything too heavy in it the.. In the case of Rear Sets replacement, there's no Risk to break, so I'm pretty comfortable with that! When you put a heavy object on it, there is a possibility of damaging the lock part of Seat measure
Please refer to the following instructions for installation
When you install the Base of GIVI Mono-lock, you need to check the position of the hole on the Base side and the position of the base The holes on the rear rack side do not fit perfectly, so be careful The two holes in the original and the Gold genus on the reverse side of the rear rack Replace the bolts holding the parts with GIVIBase parts and tighten them together (See the second image of the image)
It is necessary to fix the GIVIBase side of the Bolt 3 points, but the Bolt that comes to the Center In order to fix the top cover of the Base, you must turn the part where the screw holes are located into a Drill or Nipper Drilling process by using a (Image Quantity:1 Set of 4 pcs. See eyes)
? Plug the holes on the side of the rear rack that you are not using with appropriate tape (See the sixth image.)
Use three bolts attached to GIVI to fix the base and the rear rack At this time, because it was judged that the wavy Plate of GIVIBase attachment was unnecessary, Home I installed a Washer purchased at center instead (Refer to the fifth image of the image)
? When you install it as it is, there will be a large gap between Seat Cowl and the side of the rear rack You will not Because of the gap of about three centimeters, rain and dust can get in as much as they want, and if you work hard enough, you can take out the stuff inside Level, so it's a Waterproof Crevice Tape sold at Home Center (Thick Sponge that won't soak up water) Overlap and paste (Images 3 and 5.)View Detail
* The BEST and MUST store to find Japanese parts. * Register now for amazing deals and other special offers! *Over 800,000 listed items. It's hard NOT to find your parts.
SIGN IN TO WEBIKE JAPAN
Please enter email at least 6 characters.
Please enter a valid email address.
Email is already in use.
Your account has been banned.
Email address and/or password is not match.
Authentication with facebook fail.Please try again.
Please select How did you get to know about Webike Japan?
OR
YOUR ACCOUNT HAS BEEN CREATED!
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.
Get on your grid by register your motorcycle! About our "Mybike" service
"Easier to Search Items" It helps you to search items to fit for your motorcycle!
"Get Much Valuable Information" It helps you to get special deals, newly listed items and closeouts about your motorcycle!
"Easy to Register" It requires only your motorcycle manufacturer, model name and model year!