- When the exhaust pipe was removed, the exhaust valve was too white and we wanted to reduce the engine heat generation.Dial was adjusted at the specified value, and EngineCheckLamp was illuminated when...Read More
- Peyton PlaceCABTON Exhaust SystemIt does not correspond to JMCA.(Injection type) installed on a Model 5 SR.I bought this product because the stalling and after fire was terrible.Quantity with Manufact...Read More
- I installed it on a 2021model DL1000 V-STROM650XT. The sub harness included with the unit was complete-on, and the warning light does not come on when the engine is started, so it seems to be working ...Read More
- I think it is easy to install just because of the large size of the cowl. I did not feel the torque increase as much as the exhaust system change. Is the standard setting good or bad? Well, will it pr...Read More
- I don't see much difference.Easy to divert to other modelsRead More
- The car is NORMAL except for the appearance of the Custom.I was told that the body feel was about the difference between a two-seater and a one-seater, but not by much.As expected, I don't think there...Read More
- I bought it from a different place and no Impression, so I'm posting it!It's a long storySettingCatalyst tampering with one, one, none 2 1I thought the PowerSide Torque was good enough for commuting i...Read More
- I removed the Fuel Tank and connected the Coupler to the rear of the Battery The LED Lamp lighting of Green with key ON was also confirmed The LED Lamp lighting of Green at key ON was also confirmed B...Read More
- The Knob of the Setting was not off, so I had it repaired The thumping at SHIFT UP at mid to low speed has been considerably reduced And the power at low and medium speed increasedRead More
- After the installation, I can feel the effect of the performance and I am satisfied with it, but the new body that was sent to me is It did not have Right SideKnob on it I wanted it to be replaced, so...Read More
- The enclosed Instruction Manual is difficult to understand Connect the red side Cable to the forward cylinder Then make a mistakeCorrectly 'Cable with RedWhite Speckled Wiring is a forward cylinder, R...Read More
- Body connection is easy enough to connect Coupler Spec.. However, Wiring of Motorcycle Body was too tight in the Frame, because the Coupler was caught up and I could not pass through it, I was struggl...Read More
- 【vehicle inspection】I attempted to go through the inspection on the vehicle inspection, I passed without problems. Motorcycle passed, 11 years exhaust Gas (Legal regulations are loose) , Catalyst of O...Read More
- Wiring is super easy. Is quality like this one?. Also, since the electronic parts are solidified with resin, the contraction during drying causes the case to deform and the lid will not close as it is...Read More
- Z1000 15 Attached to OverFull Exhaust System.Torque feeling at low and medium speed is up and Donzuki is gone.BagFire has a degree of feeling that it felt less than before.Approximately 30,000 yen is ...Read More
- Slip-on SilencerSpec. We installed it in ZX - 14R. There is no dramatic change, but I do not clearly know where, but clearly I understand something different.Body is Material : It was Plastic when I t...Read More
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING